|Table of Contents|

Load-sharing characteristics of water-lubricated rubber elastic supported tilting-pad thrust bearing for rim-driven thrusters(PDF)

《交通运输工程学报》[ISSN:1671-1637/CN:61-1369/U]

Issue:
2021年02期
Page:
138-149
Research Field:
载运工具运用工程
Publishing date:

Info

Title:
Load-sharing characteristics of water-lubricated rubber elastic supported tilting-pad thrust bearing for rim-driven thrusters
Author(s):
NING Chang-xiong1; 2;  YAN Xin-ping1; 2; 3;  OUYANG Wu1; 2; 3
(1. School of Energy and Power Engineering, Wuhan University of Technology, Wuhan 430063, Hubei, China; 2. National Engineering Research Center for Water Transport Safety, Wuhan University of Technology, Wuhan 430063, Hubei, China; 3. Key Laboratory of Marine Power Engineering and Technology, Wuhan University of Technology, Wuhan 430063, Hubei, China)
Keywords:
rim-driven thruster;  water-lubricated elastic supported tilting-pad thrust bearing;  wireless telemetry;  film pressure distribution;  lubrication status;  load-sharing characteristic
PACS:
U664
DOI:
10.19818/j.cnki.1671-1637.2021.02.012
Abstract:
To study the load-sharing characteristics of water-lubricated thrust bearings supported by rubber pads for rim-driven thrusters(RDT), a test method for the load-sharing characteristics of thrust bearings was proposed. On a multifunctional vertical water-lubricated test rig, water-lubricated thrust bearings supported by rubber pads for RDT with an inner diameter of 124 mm and an outer diameter of 196 mm were used as test objects. A section of the bearing average radius was selected on the disk surface, where the miniature pressure and temperature sensors were symmetrically arranged rotated with the shaft. The full pad water film pressure distribution and thrust disk temperature were obtained by using the wireless telemetry technology. By presetting the pad height difference and the thrust disk static tilt to simulate the situation of eccentric load, the influence rules of load and speed changes on the water film pressure distribution, friction coefficient, and thrust disk temperature were studied. Research result shows that the load sharing effect of elastic support changes with the changeof working conditions. When the rotation speed is constant, the increase of load increases the deformation of rubber pads of each pad, thereby enhancing the effect of load sharing. The tilt degree of thrust disk increases with an increase of the rotation speed, which exacerbates the uneven load of pad. In the design of load sharing of a rubber elastic supported tilting pad structure for RDT, not only the manufacturing and installation factors of uneven thrust disk and pad, but also the speed and load of bearing should be considered. According to the relationship between the pressure distributions of each bearing pad and the working condition, the bearing's contact load ratio increases when the rotation speed is 100 r·min-1 and the load is 0.35 MPa. Therefore, the water film pressure test provides a new way to distinguish the bearing lubrication state. 1 tab, 16 figs, 31 refs.

References:

[1] TUOHY P M, SMITH A C, HUSBAND M, et al. Rim-drive marine thruster using a multiple-can induction motor[J]. IET Electric Power Applications, 2013, 7(7): 557-565.
[2] YAN Xin-ping, LIANG Xing-xin, OUYANG Wu, et al. A review of progress and applications of ship shaft-less rim-driven thrusters[J]. Ocean Engineering, 2017, 144: 142-156.
[3] 蒋仲廉,初秀民,严新平.智能水运的发展现状与展望——第十届中国智能交通年会《 水路交通智能化论坛》 综述[J].交通信息与安全,2015,33(6):1-8.
JIANG Zhong-lian, CHU Xiu-min, YAN Xin-ping. Developments and prospects of intelligent water transport: a review of the symposium on intelligent water transport, in conjunction with the 10th annual meeting of China ITS[J]. Journal of Transport Information and Safety, 2015, 33(6): 1-8.(in Chinese)
[4] KIM K, LEE M, LEE S, et al. Optimal design and
experimental verification of fluid dynamic bearings with high load capacity applied to an integrated motor propulsor in unmanned underwater vehicles[J]. Tribology International, 2017, 114: 221-233.
[5] 张 帆,王 祥,奚延辉,等.自适应平衡梁轴承的均载能力及影响因素研究[J].润滑与密封,2017,42(9):6-11.
ZHANG Fan, WANG Xiang, XI Yan-hui, et al. Research of sharing load and influencing factors of tilting pad thrust bearing with adaptive equalizing beams supported[J]. Lubrication Engineering, 2017, 42(9): 6-11.(in Chinese)
[6] 杨期江.柔性阻尼支承可倾瓦轴承油膜动力及减振特性研究[D].广州:华南理工大学,2016.
YANG Qi-jiang. Research on oil film dynamic and vibration reduction characteristics of flexible damping pivot tilting pad bearing[D]. Guangzhou: South China University of Technology, 2016.(in Chinese)
[7] NING Chang-xiong, LIANG Xing-xin, OUYANG Wu, et al. Simulation analysis on lubrication performance of water-lubricated elastic supported tilting pad thrust bearing[C]∥IEEE. 2019 5th International Conference on Transportation Information and Safety(ICTIS). New York: IEEE, 2019: 437-445.
[8] 梁兴鑫,严新平,刘正林,等.水润滑可倾瓦推力轴承设计与性能分析[J].交通运输工程学报,2017,17(4):89-97.
LIANG Xing-xin, YAN Xin-ping, LIU Zheng-lin, et al. Design and performance analysis of water-lubricated tilting pad thrust bearing[J]. Journal of Traffic and Transportation Engineering, 2017, 17(4): 89-97.(in Chinese)
[9] LIANG Xing-xin, YAN Xin-ping, OUYANG Wu, et al.
Experimental research on tribological and vibration performance of water-lubricated hydrodynamic thrust bearings used in marine shaft-less rim-driven thrusters[J]. Wear, 2019, 426: 778-791.
[10] LIANG Xing-xin, YAN Xin-ping, OUYANG Wu, et al.
Thermo-elasto-hydrodynamic analysis and optimization of rubber-supported water-lubricated thrust bearings with polymer coated pads[J]. Tribology International, 2019, 138: 365-379.
[11] HESHMAT H, PINKUS O. Misalignment in thrust bearings including thermal and cavitation effects[J]. Journal of Tribology, 1987, 109(1): 108-114.
[12] ILIEV H. Failure analysis of hydro-generator thrust bearing[J]. Wear, 1999, 225: 913-917.
[13] IORDANOFF I, STEFAN P, BOUDET R, et al. Dynamic analysis of a thrust bearing-effect of misalignment and load[J]. Journal of Engineering Tribology, 1995, 209(3): 189-194.
[14] BERGER S, BONNEAU O, FRÊNE J. Influence of axial
thrust bearing defects on the dynamic behavior of an elastic shaft[J]. Tribology International, 2000, 33(3/4): 153-160.
[15] BERGER S, BONNEAU O, FRÊNE J. Influence of a
levelness defect in a thrust bearing on the dynamic behaviour of an elastic shaft[J]. Journal of Sound and Vibration, 2002, 249(1): 41-53.
[16] SAN ANDRAE'GS L. Effects of misalignment on turbulent
flow hybrid thrust bearings[J]. Journal of Tribology, 2002, 124(1): 212-219.
[17] WANG Y, WANG Q J, LIN C. A mixed-EHL analysis of effects of misalignments and elastic deformations on the performance of a coupled journal-thrust bearing system[J]. Tribology International, 2006, 39(4): 281-289.
[18] WANG Lei, JIANG Shu-yun. Centrifugal effects on the
dynamic characteristics of high speed hydrostatic thrust bearing lubricated by low viscosity fluid[J]. Journal of Engineering Tribology, 2014, 228(8): 860-871.
[19] 蒋秀龙,汪久根.轴线偏斜对可倾瓦推力轴承润滑性能的影响[J].润滑与密封,2011,36(3):9-12.
JIANG Xiu-long, WANG Jiu-gen. Effect of misalignment on thermal elastohydrodynamic lubrication of tilting-pad thrust bearing[J]. Lubrication Engineering, 2011, 36(3): 9-12.(in Chinese)
[20] SHI Jiang-hai, CAO Hong-rui, JIN Xiao-liang. Investigation on the static and dynamic characteristics of 3-DOF aerostatic thrust bearings with orifice restrictor[J]. Tribology International, 2019, 138: 435-449.
[21] TEO C J, SPAKOVSZKY Z S. Analysis of tilting effects and geometric nonuniformities in micro-hydrostatic gas thrust bearings[J]. Transactions of the ASME, 2006, 128: 606-615.
[22] 刘 超.高速静压推力轴承中心加载与偏载润滑性能对比研究[D].哈尔滨:哈尔滨理工大学,2019.
LIU Chao. Comparative study on lubrication performance of high speed hydrostatic thrust bearing at center loading and eccentric loading[D]. Harbin: Harbin University of Science and Technology, 2019.(in Chinese)
[23] 龚玉平.碟簧支承圆形瓦推力轴承性能研究[D].哈尔滨:哈尔滨理工大学,2018.
GONG Yu-ping. Research on the performance of spring supported circular tile thrust bearings[D]. Harbin: Harbin University of Science and Technology, 2018.(in Chinese)
[24] 张赣波,赵 耀,储 炜,等.船舶可倾瓦推力轴承润滑油膜的轴向动特性计算方法[J].船舶力学,2017,21(5):603-612.
ZHANG Gan-bo, ZHAO Yao, CHU Wei, et al. Calculation method for axial dynamic characteristics of lubricant oil film in marine tilting pad thrust bearing[J]. Journal of Ship Mechanics, 2017, 21(5): 603-612.(in Chinese)
[25] CHA M, ISAKSSON P, GLAVATSKIH S. Influence of pad compliance on nonlinear dynamic characteristics of tilting pad journal bearings[J]. Tribology International, 2013, 57: 46-53.
[26] GUO An-nan, WANG Xiao-jing, JIN Jian, et al. Experimental test of static and dynamic characteristics of tilting-pad thrust bearings[J]. Advances in Mechanical Engineering, 2015, 7(7): 1-8.
[27] GLAVATSKIH S B, FILLON M. TEHD analysis of thrust bearings with PTFE-faced pads[J]. Journal of Tribology, 2006, 128(1): 49-58.
[28] GLAVATSKIKH S B. Steady state performance characteristics of a tilting pad thrust bearing[J]. Journal of Tribology, 2001, 123(3): 608-615.
[29] 王 楠,孟庆丰.旋转机械无线监测中的多普勒效应[J].振动、测试与诊断,2016,36(4):751-755.
WANG Nan, MENG Qing-feng. Research on doppler effect in wireless monitoring on rotating machinery[J]. Journal of Vibration, Measurement and Diagnosis, 2016, 36(4): 751-755.(in Chinese)
[30] 董从林.水润滑橡胶轴承材料的摩擦磨损机理及磨损寿命预测研究[D].武汉:武汉理工大学,2015.
DONG Cong-lin. Study on friction and wear mechanism and wear life[D]. Wuhan: Wuhan University of Technology, 2015.(in Chinese)
[31] 梁兴鑫.无轴推进器水润滑弹支可倾瓦推力轴承润滑模型及性能研究[D].武汉:武汉理工大学,2019.
LIANG Xing-xin. Study on lubrication models and performance of elastically-supported water-lubricated tilting pad thrust bearings of shaftless thrusters[D]. Wuhan: Wuhan University of Technology, 2019.(in Chinese)

Memo

Memo:
-
Last Update: 2021-06-01