|Table of Contents|

Stress response and fatigue damage assessment of high-speed train gearbox(PDF)

《交通运输工程学报》[ISSN:1671-1637/CN:61-1369/U]

Issue:
2018年01期
Page:
79-88
Research Field:
载运工具运用工程
Publishing date:

Info

Title:
Stress response and fatigue damage assessment of high-speed train gearbox
Author(s):
LI Guang-quan;  LIU Zhi-ming;  GUO Ru-bing;  XU Ning
School of Mechanical, Electronic and Control Engineering, Beijing Jiaotong University, Beijing 100044, China
Keywords:
vehicle engineering;  gearbox;  torque load;  vibration load;  stress response;  fatigue damage
PACS:
U260.332
DOI:
-
Abstract:
A high-speed train line test was carried out, the GPS signal and mechanical characteristics of gearbox structure were researched, and the stress-time history curves under torque load and vibration load were obtained. The stress response characteristics of gearbox under the action of torque load and vibration load were analyzed, and the stress spectrum was compiled. The influencing parameter of fatigue damage was used to reflect the effect degrees of torque load and vibration load on the fatigue damage of gearbox. Research result shows that under torque load, the alternative change between train traction and braking can cause greater stress response of gearbox, and the maximum stress amplitude is 25.80 MPa. In the braking condition, the stress of gearbox fluctuates like ladder wave. The frequency of high stress amplitude at the end of gearbox hanger seatis higher at low speed than at high speed, and the influencing parameter of fatigue damage declines by 60.0% from 0.20 to 0.08. Under vibration load, when train speed drops from 350 km·h-1 to 200 km·h-1, the stress response strength at the end of gearbox hanger seat declines by 53.4% from 2.08 MPa to 0.97 MPa. The gearbox stress amplitude is lower at the front of train than at the tail at the same speed level. When the train transforms from traction state to inert operation, the stress response strength decreases by 70.6% from 3.4 MPa to 1.0 MPa. When the train transforms from low speed to high speed, the influencing parameter of fatigue damage at the end of gearbox under vibration condition increases by 27.9 times from 0.009 to 0.260. 1 tab, 17 figs, 25 refs.

References:

[1] 黄冠华,王兴宇,梅桂明,等.内外激励下高速列车齿轮箱箱体动态响应分析[J].机械工程学报,2015,51(12):95-100.HUANG Guan-hua, WANG Xing-yu, MEI Gui-ming, et al. Dynamic response analysis of gearbox housing system subjected to internal and external excitation in high-speed train[J]. Journal of Mechanical Engineering, 2015, 51(12): 95-100.(in Chinese)
[2] 常程城.高速列车齿轮箱线路试验及振动传递关系研究[D].北京:北京交通大学,2015.CHANG Cheng-cheng. Research on transmission of vibration of high-speed train gear box and gear box line test[D]. Beijing: Beijing Jiaotong University, 2015.(in Chinese)
[3] 黄冠华,周 宁,张卫华,等.动态激励下高速列车齿轮传动系统振动特性分析[J].铁道学报,2014,36(12):20-26.HUANG Guan-hua, ZHOU Ning, ZHANG Wei-hua, et al. Vibration characteristics of gear transmission system of high-speed train under dynamic excitation[J]. Journal of the China Railway Society, 2014, 36(12): 20-26.(in Chinese)
[4] 李广全,刘志明,王文静,等.高速动车组齿轮箱疲劳裂纹机理分析研究[J].机械工程学报,2017,53(2):99-105.LI Guang-quan, LIU Zhi-ming, WANG Wen-jing, et al. Fatigue crack mechanism study on high-speed EMU gearbox[J]. Journal of Mechanical Engineering, 2017, 53(2): 99-105.(in Chinese)
[5] FOONG Chee-hoe, PAVLOVSKAIA E, WIERCIGROCH M, et al. Chaos caused by fatigue crack growth[J]. Chaos, Solitons and Fractals, 2003, 16(5): 651-659.
[6] FOONG Chee-hoe, WIERCIGROCH M, DEANS W F. Novel dynamic fatigue-testing device: design and measurements[J]. Measurement Science and Technology, 2006, 17(8): 2218-2226.
[7] 王文静,惠晓龙,马纪军.高速列车设备舱支架疲劳裂纹机理研究[J].机械工程学报,2015,51(6):142-147.WANG Wen-jing, HUI Xiao-long, MA Ji-jun. Fatigue crack mechanism research on high speed train equipment cabin frame[J]. Journal of Mechanical Engineering, 2015, 51(6): 142-147.(in Chinese)
[8] DAMIR A N, ELKHATIB A, NASSEF G. Prediction of fatigue life using modal analysis for grey and ductile cast iron[J]. International Journal of Fatigue, 2007, 29(3): 499-507.
[9] 姚起杭,姚 军.结构振动疲劳问题的特点与分析方法[J].机械科学与技术,2000,19(增):56-58.YAO Qi-hang, YAO Jun. The behavior and analysis of structure vibration fatigue[J]. Mechanical Science and Technology, 2000,19(S): 56-58.(in Chinese)
[10] 姚起杭,姚 军.工程结构的振动问题[J].应用力学学报,2006,23(1):12-15.YAO Qi-hang, YAO Jun. Vibration fatigue in engineering structures[J]. Chinese Journal of Applied Mechanics, 2006, 23(1): 12-15.(in Chinese)
[11] HAIBA M, BARTON D C, BROOKS P C, et al. Review of life assessment techniques applied to dynamically loaded automotive components[J]. Computers and Structures, 2002, 80(5/6): 481-494.
[12] AYKAN M, CELIK M. Vibration fatigue analysis and multi-axial effect in testing of aerospace structures[J]. Mechanical Systems and Signal Processing, 2009, 23(3): 897-907.
[13] MOON S I, CHO I J, YOON D. Fatigue life evaluation of mechanical components using vibration fatigue analysis technique[J]. Journal of Mechanical Science and Technology, 2011, 25(3): 631-637.
[14] HAN Seung-ho, AN Dae-gyun, KWAK Seong-jong, et al. Vibration fatigue analysis for multi-point spot-welded joints based on frequency response changes due to fatigue damage accumulation[J]. International Journal of Fatigue, 2013, 48: 170-177.
[15] SEYRANIAN A P, SOLEM F, PEDERSEN P. Multi-parameter linear periodic systems: sensitivity analysis and applications[J]. Journal of Sound and Vibration, 2000, 229(1): 89-111.
[16] RAGHOTHAMA A, NARAYANAN S. Bifurcation and chaos in geared rotor bearing system by incremental harmonic balance method[J]. Journal of Sound and Vibration, 1999, 226(3): 469-492.
[17] SONG Chao-sheng, ZHU Cai-chao, LIU Huai-ju, et al. Dynamic analysis and experimental study of a marine gearbox with crossed beveloid gears[J]. Mechanism and machine theory, 2015, 92: 17-28.
[18] 陈智芳,姚建伟.高速万向轴式动力转向架体悬齿轮箱的研究[J].机车车辆工艺,2002(8):8-12.CHEN Zhi-fang, YAO Jian-wei. Development of suspended gearboxes for high speed cardan-shaft power bogies[J]. Locomotive and Rolling Stock Technology, 2002(8): 8-12.(in Chinese)
[19] 袁文东.标准动车组齿轮箱箱体强度分析与寿命预测[D]. 北京:北京交通大学,2016.YUAN Wen-dong.Analysis on the strength and fatigue-life prediction of standard high-speed EMU gearbox housing[D]. Beijing: Beijing Jiaotong University, 2016.(in Chinese)
[20] 杨广雪,李广全,刘志明,等.轮轨激励下高速列车齿轮箱箱体振动特性分析研究[J].铁道学报,2017,39(11):46-52.YANG Guang-xue, LI Guang-quan, LIU Zhi-ming, et al. Vibration characteristics analysis of gearbox housing system of high-speed train subjected to wheel-rail excitation[J]. Journal of the China Railway Society, 2017, 39(11): 46-52.(in Chinese)
[21] 王 萌,李 强,孙守光.基于应力响应的多频率激励载荷识别研究[J].铁道学报,2015,37(2):27-33.WANG Meng, LI Qiang, SUN Shou-guang. Study of multi-frequency exciting load identification based on dynamic stress response[J]. Journal of the China Railway Society, 2015, 37(2): 27-33.(in Chinese)
[22] 任尊松,刘志明.高速动车组振动传递及频率分布规律[J].机械工程学报,2013,49(16):1-7.REN Zun-song, LIU Zhi-ming. Vibration and frequency domain characteristics of high speed EMU[J]. Journal of Mechanical Engineering, 2013, 49(16): 1-7.(in Chinese)
[23] 刘志明.随机载荷下焊接构架疲劳寿命及可靠性研究[D].北京:北京交通大学,2001.LIU Zhi-ming. A research on fatigue life and reliability of welding frame under random loads[D]. Beijing: Beijing Jiaotong University, 2001.(in Chinese)
[24] 周素霞,李福胜,谢基龙,等.基于损伤容限的动车组车轴实测载荷谱等效应力评价[J].机械工程学报,2015,51(8):131-136.ZHOU Su-xia, LI Fu-sheng, XIE Ji-long, et al. Equivalent stress evaluation of the load spectrum measured on the EMU axle based on damage tolerance[J]. Journal of Mechanical Engineering, 2015, 51(8): 131-136.(in Chinese)
[25] 王 萌,李 强,孙守光.耦合作用下各载荷对结构疲劳损伤影响程度的评估方法[J].中国铁道科学,2015,36(3):94-99.WANG Meng, LI Qiang, SUN Shou-guang. Evaluation method for influence degree of each load on fatigue damage of mechanical structure under coupling effect[J]. China Railway Science, 2015, 36(3): 94-99.(in Chinese)

Memo

Memo:
-
Last Update: 2018-03-28